Coil-Sert™ inserts are supplied in coarse and fine threads. Type 2, Type 4 and Type 6 Tooling are used for finer pitch inserts, which are larger in the free state than the coarse pitch inserts. They have to be "pre-wound" to a smaller diameter for installation. Type 1, Type 3 and Type 5 Tooling (threaded mandrel) are used for coarse pitch inserts.
Type 1 Installation Tool Threaded Mandrel (Sizes 2-56 and 3-56)
Type 2 Hand Inserting Tool (Prewinder Tool)
Type 3 Installation Tool (Threaded Mandrel)
Type 4 Non-Captive Prewinder
Type 5 Installation Tool (Threaded Mandrel)
Type 6 Installation Tool (Threaded Mandrel With Prewinder)
* use standard needle nose pliers to remove tangs on this size insert
* use standard needle nose pliers to remove tangs on this size insert
Extracting Tool
This tool is used to remove Coil-Sert™ inserts. Apply the tool to the insert, striking the head of the tool lightly while turning it counter clockwise, maintaining steady downward pressure.
Tang Break-Off Tool
This tool is used to remove the driving tang of Coil-Sert™ inserts after they have been installed to eliminate their interference with the end of the assembled bolt. The operation of the tool is automatic, having a spring loaded punch that strikes a sharp blow against the tang of the installed insert.)
Go & No Go Gages
Coil-Sert™ S.T.I. thread plug gages are used to check the accuracy of the tapped hole. If the tapped hole is correct, the finished thread will also be accurate when the insert is installed. It is not necessary to gage the installed insert.
* use standard needle nose pliers to remove tangs on this size insert
* use standard needle nose pliers to remove tangs on this size insert
